jdm b16a into 2k hx

[monicle]

Ive looked and lookd and I cant seem to find a straight answer about a couple things. Am I going to need the axles? The only information I can find that talked about the axles is written for 4th gen civics. Aslo with the 2000 civic beinc considered an obd2b and the b16a being considered an obd2 am i going to have anything extra to wire up? Im hoping to get this swap going by next month so any help would be great.

[b18cya-T]

when you swap the motors, it should come with the new ECU & sensors. that'll take care of your obd worries

& you'll probably need the axles

[12seccivy]

you will need the axles from the b16a. motor and tranny.
there's also a half shaft(axle to tranny) on the drivers side.
the civic axles wont fit the B series tranny
the B series axles however fit in the civic hubs.
as far as the ecu goes. i'm not aware of an ob2 setup from japan, only the b16a from the 99-00 si,if yours is not obd2(JDM) then you can convert yours to obd1 with a harness adaptor
hope this helps.

[HONDA GHANDI]

Yeah what 12sec said.

Oh and you will need to wire up the VTEC.

[12seccivy]

aww GHANDI!
i think i wet your bed too!!!

[HONDA GHANDI]

Youre not the only one dood.

[monicle]

sweet actually the hx already has vtec so i dont have to wire anything up there. Sweet tho thanks. Have to check to make sure this swap comes with the axles.

[scoobyworx]

If your getting the B16A2 it should just be a direct bolt in. Since your car is OBDII, and the A2 is OBDII also then you shouldnt have any problems with all the wiring or what not.