H22 OP sending unit?

[PhntmSk8r]

Where can i tap this thing into the block?

Is the factory sending unit right below the intake manifold or is it lower then that?

I cant seem to find where the factory one is, since thers only 1 sensor on the back of the block and it doesnt look anything like what honda showed me...

Theres also a hole/opening below the oil filter, would this be a good place to tap the sending unit into?

its a 93 h22 vtec.

[Martian]

its the sole sensor on the back of the block. Get the proper line and run some braided up to the firewall from the block and run a T fitting. Put both senders there.

[M@]

:D More or less the same thing I said in his other thread.

[PhntmSk8r]

its the sole sensor on the back of the block. Get the proper line and run some braided up to the firewall from the block and run a T fitting. Put both senders there.

already have that covered re-read my post, i was asking if he knew which hole it went in since my block already had a dis-fucntional sending unit in it, i wasnt sure if it didnt work kuz it was in the wrong location, or if it was because the unit itself was bad.

I got it all figured out and it works now.