Cats and O2

[inigo]

Do you carry any high flow cats ? Would you happen to know anyone that can build/weld my a custom exhaust other than the usual exaust shops that charge you 300 for a standard muffler ? ( i have resonator,and muffler...need cat )

[Kwando]

TC's is the place to go to... tobi did my 3" exhaust with a muffler... my 3" test pipe with a flex section because my DP didn't have one...

[inigo]

TC's is the place to go to... tobi did my 3" exhaust with a muffler... my 3" test pipe with a flex section because my DP didn't have one...

Were the bends crush bent ? Im just curious to know how much a simple ( i mean......... copying the stock setup with larger dia piping ( 2.25 inches ) ) would cost. I guess i can dump the cat...but i dont feel like killing our earth.

[Deceptakhan]

Were the bends crush bent ? Im just curious to know how much a simple ( i mean......... copying the stock setup with larger dia piping ( 2.25 inches ) ) would cost. I guess i can dump the cat...but i dont feel like killing our earth.

Don't feel like killing the earth? Hmmmm.

[inigo]

Don't feel like killing the earth? Hmmmm.

Ozone...sorry. Its not realy that..but id prefer to have cat. What i realy need is hp more than Tq at this point. The car has tq down low, but it weighs nothing and i could use some of that up top. Id sacrafice tq for HP.

[HONDA GHANDI]

I can do crush 3 inch pretty cheap, mandrel bends are about twice as much. I carry 2.5 and 3 inch high flow cats.

[inigo]

I can do crush 3 inch pretty cheap, mandrel bends are about twice as much. I carry 2.5 and 3 inch high flow cats.

so were looking at 300 or so for mandrel bent 2.5 ?

[HONDA GHANDI]

No, about $450