b18a1bottom end with b18b1 head

[NoWheels]

will the b18b1 head with intake manifold work on my b18a1 block with no modification??

[Terry]

www.google.com

[95GSRB18C]

yes it will work fine.

[NoWheels]

so i can just put it on and run...

[B20badboy]

as long as you are not changing odb's like odb1 to odb2 etc... unless you know what you are doing.

[2genCRX]

^ werd so 92-93 bottom with a 94-95 head

[nicklk]

You wont have any problems at all.....

You could put a obd2 LS head on a 91 LS (obd-0) you would just have to use the intake manifold from the 91.....But you wont have any problems at all....

[nicklk]

Just make sure you use the b18b valve lash when you go to adjusting the valves.....

[NoWheels]

sweet thanksi hope this works fine i want to do it because i am getting a strang tick from my head and im getting this one for dirt cheap...with LOW MILES... and i have to adjust the valves??

[B20badboy]

That tick is either a valve adjustment hel maybe even a bad gasket (exhaust)

[NoWheels]

hmm.. i see but would using the b1 head do anything performance wise because its so cheap and if it will do something for me in the long run i figure why not just do it

[NoWheels]

and what is valve lash?