Compression test ?

[HondaPower]

I plan to do a compression check on an 94 Integra. I checked out c-speedracing.com and it says to pull the fuel FI injection fuse. Where would that be located? What is it labeled as? It also says to crank the motor 5 times... What does that exactly means?

[95GSRB18C]

just like it says. pull the spark plugs and the fuel fuse, thread the tester into the hole and turn the key and hold it over for 5 or 6 cranks, see what the reading is and move onto the next one.

[HondaPower]

Where is the fuel fuse? What is it labeled at on the fuse cover. I coudn't see anything.

[Nate]

I just pull the ECU fuse from inside the engine bay box.

[rmcdaniels]

I just put an alligator clip on my solenoid terminal to a small switch to the positive terminal on the battery, then I can hold the TB open by hand and crank it from under the hood. I crank it until it doesn't go up any more, usually 5-10 revolutions.

[HondaPower]

I've heard about the ecu fuse, I guess I'll do that. Rmcdaniels has a pretty good way of doing it!

[rmcdaniels]

you can buy a fancy switch for $10, like this:

http://www.shop.com/op/aprod-p24029289-k24-g4-~remote+starter+switch-nover?sourceid=3


My setup is even cheaper , maybe $5

[HondaPower]

That's awesome, I might try that!

[Nate]

This is the one I use, it is even cheaper and makes a HUGE difference since you can do it all yourself. I'm not sure if they have a HF in the Springs but everything in the store is on sale like 20% of the time.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=35448

I used to use a 50 cent alligator clip and touch it to the battery but it gets annoying holding it there and your hand/your car moves around.