FS: Custom .074" and .120" Cometic MLS head gaskets for B-series VTEC motors

[rmcdaniels]

Here are a couple of new gaskets that I had made but never used, good for lowering the compression on a stock motor so you can run more boost safely. They will fit on up to a 85mm bore. I listed them on ebay with pictures and a better description, so if you'd like them then please bid:


http://motors.search.ebay.com/_W0QQsassZrmcdaniels65xs

[B20badboy]

Hey will these work on a LS vtec (B18a lower end and a GSR head?) What were you looking to get for them? I am currently in Plymouth N.C. and will be driving thru Raleigh the week after next.

[rmcdaniels]

I think it should work, as far as I know the difference between the VTEC and non-VTEC gaskets is the size of the dowel holes (bigger for VTEC) and the hole for the VTEC oil supply (not used on a LS VTEC). I'm not 100% sure though, as I've never built an LS VTEC motor.

I want as much as I can get, but reserve is set at $58 for the .074" gasket and $95 for the .120" gasket.

[rmcdaniels]

TTT

[Nick_S]

Damn to bad you didn't have this for sale a coupple monts ago.

[rmcdaniels]

Yeah, they've actually been sitting around my living room for a couple of months, I just got around to putting them up for sale.

[ripperbone]

i know its been some time but I was wondering if you still had them for sale?