oxygen sensor is slow to respond...

[nathanie1]

this is the cel code that ive been getting on my 99 Si since my turbo was installed. it was fine before. does this just mean i have to change the 02 sensor? is there any way to make it fast to resond...? haha well thanks for your time

[M@]

....it's saying "slow to respond"? Is that even a code? I've NEVER heard of a code like that before. BTW, I own a '99 Si Turbo as well.. so uhh.. yeah, I'm pretty sure there's not a code that says "slow to respond" lol... I'm tdrunk though. *shrugs*

[HONDA GHANDI]

What is the actual trouble code number? That would help me tremendously rather than sorting through about 600 codes looking for a description.

[nathanie1]

yes it is a real code the code number is P1033

[M@]

That's interesting. I'll be watching this thread cuz this could be handy to know...

[HONDA GHANDI]

You mean. PO133. There is no 1033

If you have a AF gauge check the connection where it taps into the sensor. This can cause a voltage stablization issue causing the ECU to set this code. If not, there are only two possible scenarios that can cause this problem, a failed or failing oxygen sensor or a wiring/ECU problem.

[nathanie1]

thanks, i think it might be a wiring problem cuz after the turbo went in my right turn signal has been going kinda crazy as well. i dunno if theres any connection but maybe. do u think you could take a look at this tomarrow?

[HONDA GHANDI]

No, I have a full shop until at least next week.