car acting funny after swap?

[urhomieblaze]

i'm still working on the wiring on my eg/gsr swap but haven't had any luck,
when i turn the koeo it makes the main relay go ape shit clicking and my tach and speedo start moving on their own. anyone had this happen to them? i checked the main relay how it says in the shop manual and it tested good.
i pulled the codes and got a code 14 i think its iac, if my wires at the iac are crossed at all, would it affect it like that?

[stu]

Is it acting like you swapped a better motor into it? ;)

[urhomieblaze]

nah, it's acting all scared, like a little bitch. makes me want to practice my stabbin. yo

[urhomieblaze]

i finally got it running, my battery post was messed up(i'm a dingus), it started to crank when i put the voltmeter on it to see how far voltage dropped when it cranked, so i cleaned them and had to put a penny in my negative to secure it, but it runs now. just loud as all hell cause of the header doesnt reach. still have the code 14 for now..

the gsr header is about 6-8 inches too short for my exhaust, would a b16 header fix that?

[Nate]

For exhaust, it all lines up if you use the correct header / cat. The B pipes are all the same. If you use the header/cat from the motor it should line up. If you don't use that stuff you'll have to throw something together.