best for boost?????????

[oldskoolracer]

i have an extra b16 block and i want to throw one complete stock longblock to put in the sol right now.


well,,,, for boost would you use a GSR b18c head or should i wait and find a B16 head


my stock block is getting rebuilt as soon as it come out of the car so this is a get me by motor.



suggestions please.

[exciv2000]

b16 head will flow better than B18C1

[stu]

Slap that B16 in my Integra. :D

[oldskoolracer]

what about compression?

[servion]

b16 heads flow better on the flowbench, this is true. However, GSR heads have less of a problem with reversion (which means that they perform better in real-life). GSR heads also have a better quench area, which will premote a faster burn and effectively reduce the chance for detonation. GSR heads also yield a higher compression. I would choose a GSR head over a b16 anyday.

[oldskoolracer]

cool, i'm going to be putting this on a stock b16 block. any suggestions?


i should be able to push 10psi, right? what's the highest you would go with stock motor

[B20badboy]

cool, i'm going to be putting this on a stock b16 block. any suggestions?


i should be able to push 10psi, right? what's the highest you would go with stock motor
Here you go servon heres your chance on the whole PSI deal again LOL

[oldskoolracer]

YEAH, what he said

[servion]

Read this: I think this is the thread that covers it pretty well:

http://www.highaltitudeimports.com/t28252-preparing-for-boost.html

[Conrad]

cool, i'm going to be putting this on a stock b16 block. any suggestions?


i should be able to push 10psi, right? what's the highest you would go with stock motor


you should be able to do about 55 pounds safe... you could probably push it to 75 if your ballzy

[jdm95integra]

^ also slap on an NOS dry kit with a 75 shoot , u be aight

[b16efhatch]

you might blow the welds on your intake manifold though.

[oldskoolracer]

but what about the pisyon rings i just fried?

[oldskoolracer]

:king: :fu: DICKS, ALL OF YOU ,





lol.

[b16efhatch]

better just go all motor cause your diamond plate floor board might fall off from the extremely high speeds.

[Conrad]

Should probably go for a spoon motor... but then again they cost a pretty penny this close to race warz

[b16efhatch]

oh, are you so wrong!! I got my spoon motor for only 2000 and I will have it in for race wars better be ready, Oh Yeah.

[oldskoolracer]

be careful you don't want that spoon motor to twist the chassis off the line

[b16efhatch]

Yeah thats what Im afraid of