PDA

View Full Version : Cluster nor signals work!

suavecito1177
02-25-2005, 10:01 PM
Ok, I just did a stock z6 swap in a 95 Civic EX and everything works great, but the turn signals don't work and none of the gauges work on the cluster. The battery light and the SRS light and the backlights work, but none of the other lights work. Also my turn signals only work with the hazard switch. I don't hear the flasher working, but that still wouldn't make the cluster stop working would it? Tomorrow I am going to change all the relay and see if that will work. I replaced all the fuses already and even swapped out the entire engine harness. Any help would be helpful. Thanks
Conrad
02-26-2005, 07:29 AM
use a voltimeter and make sure its not getting power.... if it is its the cluster.
suavecito1177
02-26-2005, 10:23 PM
Well, figured out today that the cruise control doesn't work and the clock also doesn't work. Tomorrow I am going to borrow my friends cluster and see if that's the problem, but if it's not what the hell would it be.
blue
02-26-2005, 11:24 PM
short somewhere??? ummm cheak ur bulbs and make sure they are the correct ones for ur car there should be 2 metel dots on the end of ur blinkers..if not thats ur blinker problem...as far as the cluster..did it work before becuase if not someone might have accdently snaped the needles off trying to put whatever it may be on them and just stuck them back in....GL
imback
02-27-2005, 12:31 AM
Check all your grounds on the motor/tranny. I had a similar problem with my Civic and it turned out to be the ground strap from the tranny to the frame.
Nate
02-28-2005, 09:10 AM
Did you check all your fuses? Check the underhood fuses also.
suavecito1177
02-28-2005, 11:41 AM
I've already replaced the entire engine harness and everything is hooked up right. All the bulbs are new and are the correct ones. All fuses under the hood and under the dash all are new. This is the only thing left wrong with the damn car and I'm tired of it sitting in my garage. I'm gonna go buy a Snap-On scanner and an import cartridge and just go that route. I'll let you guys know what happens. Thanks
blue
03-01-2005, 02:03 PM
yea..GL and tell us how it goes
suavecito1177
03-01-2005, 07:42 PM
Well, I tried 2 different gauge clusters yesterday and both of those did the same thing. So I know for a fact now that my cluster is good and it has to be the wiring somewhere under the dash somewhere. Still waiting on that scanner and then I'll see what the hell is the damn problem.