View Full Version : Help with Clifford Ace 300 Alarm (I cant disarm it)
02-10-2005, 05:21 PM
When I bought my car my alarm was in valet mode, today I started messing with it. I turn the car on, flip the switch and the LED light goes out. Then once I close the door, after about 30 seconds the car locks itself, the parking lights flash twice and the LED light starts flashing.
But my problem is that I cant turn the alarm off. I press the arm/disarm button and nothing happens, no beep, no flash, no nothing. So in order to get it to turn off the car alarm goes off and I have to put it back into valet mode.
Anybody have a fix?
02-10-2005, 06:54 PM
I could point and laugh at you, does that help?
02-10-2005, 09:32 PM
02-10-2005, 11:16 PM
02-11-2005, 07:17 AM
sounds like you need the remote fixed. depending on how old the alarm is some of the DEI remotes get bad solder connections. you can either order and program a new remote or i might be able to fix the old one.
02-11-2005, 10:02 AM
I went over the manual, and I did everything they said to get it out of valet mode, thanks for the link tho. You might be right about the remote, somehow the unit isn't receiving a signal
02-11-2005, 10:08 AM
Maybe your remote battery died?
02-11-2005, 10:30 AM
Same thing happened to me on my Grand Cherokee, the battery was going dead in the remote. Replaced battery and it worked fine again.
02-11-2005, 10:53 AM
Who needs Alarms, It is a totally safe world these days.
Powered by vBulletin® Version 4.1.5 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.