PDA

View Full Version : Mandrel Bends?

88Alltrac
02-10-2005, 12:07 AM
Anyone know of anywhere near Denver/Boulder that offers mandrel bent pipes? If not, where can I get U-bends and such for a good deal online?

Thanks,
Steve
David
02-10-2005, 12:12 AM
www.jegs.com
www.summitracing.com
www.jcwhitney.com
chrisbarnett01
02-10-2005, 12:24 AM
On track has a few bends in stock, only mild steel.

My favorite supplier for bends is Burns Stainless. You'll pay out the ass for Burn's though, but its worth it. If you're looking for mild steel I really can't help, mild steel sucks. Stainless is about the same price as far as raw bends, and for IC piping, aluminum isn't *that* much more than stainless.
sbiggi
02-10-2005, 08:10 AM
TEC in Golden has bends.... On track is a rip off
Brandon
02-10-2005, 05:26 PM
on track doesn't have 400lb guard dogs that will bite you
David
02-10-2005, 05:28 PM
my local Napa has mandrel bends :D
TheJackal
02-10-2005, 06:28 PM
where is on track?
88Alltrac
02-10-2005, 06:37 PM
my local Napa has mandrel bends :D

I was told mine did too but I know better, their "Mandrel Bends" were really CRUSH BENT. But if you know of one that really can get mandrel bends I may check into that.

I can get U-bends of 3" for $15 mild/stainless but not sure where to find smaller wastegate stuff 1-3/4" or so diameter. I will check the TEC place out in Golden sometime soon. What should I expect to pay from these local guys? Almost scared it will be rediculas.
PowerSportsInc
02-10-2005, 06:58 PM
Steve, give me a call. You know I'll hook you up
AcuraBro
02-10-2005, 08:32 PM
I can get them also. Any size you want up to 4".
Skaterkid
02-10-2005, 08:36 PM
where is on track?
Off of Santa Fe and Dartmouth I believe. I know its off of Santa Fe for sure.
David
02-10-2005, 08:39 PM
I was told mine did too but I know better, their "Mandrel Bends" were really CRUSH BENT. But if you know of one that really can get mandrel bends I may check into that.

I can get U-bends of 3" for $15 mild/stainless but not sure where to find smaller wastegate stuff 1-3/4" or so diameter. I will check the TEC place out in Golden sometime soon. What should I expect to pay from these local guys? Almost scared it will be rediculas.
my Napa in Elizabeth had a couple 90* mandrel elbows in various sizes mixed in with the crush bent ones.
Brandon
02-11-2005, 07:47 AM
Off of Santa Fe and Dartmouth I believe. I know its off of Santa Fe for sure.

yup, take dartmouth west to platte river dr and take a right, its right there on the right hand side.

RE: being a ripoff...
They've always matched a cheaper price if i found one except with NAAAAWZ