Oil Pressure Tap

[David]

I tapped my turbo at the oil pressure sensor on the block, and ran a line to the turbo. Should I tap it at the turbo (easier) or should I tap it at the block (have to change oil, and get dirty) or would there be any difference?

[HONDA GHANDI]

huh?

[David]

dont you sass talk me ghandi

I have an aftermarket oil pressure gauge, where in the oil system should I put the tap for it?

[1998cc]

I had this same conondurm and i tapped it at the block. If you have brass fittings don't even think about it. Is this for an autometer? I have a stainless line I am not using that you can use. -4an

[Weston-work]

Put a T on the turbo's oil feed line near the back of the block. Just don't use a brass fitting on the block... run a line from the block to the T, then connect the turbo feed line and oil pressure sender to it. Support the T so that it is not hanging from the line coming from the block.

[rmcdaniels]

I use this:

http://shop.vendio.com/funinfeenix/item/646388659/index.html