PDA

View Full Version : parting out: 94 honda civic ls vtec turbo


tek
06-14-2004, 09:26 PM
well due to the fact that my money simply cannot be made back by selling as a whole, all parts on the car are up for sale, including those not listed. All prices are best offer, but no lowballers. only contact me if you are serious, please don't waste my time. no trades as i have no car to need anything for. pictures of anything can be taken. all parts are in good working condition, as my car is running fine now. all parts have at most 75k on them, while the chassis has about 140k. please pm me with offers. if anyone wants to buy or trade for the whole car, that is still possible, not sure for how long though.

head $700 -everything, sensors, type R throttle body(62mm) 450cc injectors with resistors has gsr cams installed, but can include b16 cams instead.head is prepped and currently used on an ls/vtec head. can be used on vtec blocks with the removal of oil passage plug. set up for use with external coil.

turbo $1500 -everything, all piping, hks turbo manifold, t28 turbo, greddy type s BOV, small but effective FMIC, everything you need for turbo(minus fuel stuff) also including a custom side exit downpipe(outta front bumper) with 2 o2 sensor spots.

tranny $1000 -no grinds, short ratio(b16a SiR-II), no lsd hydro clutch. can include 6 puck racing clutch and pressure plate, just remachined the flywheel with the new clutch. tew throwout bearing and thrust bearing. can include axles left is new right is old and slightly clicking.

vtec kit $200 -everything needed to feed your vtec head with oil on ls/vtec engines, also includes dowell pins so ne head drilling is needed. just swap heads and go!

gsr ecu $175 -good for swaps or upgrade on a 92-95 civic si or ex.

LS ecu $100 -everyone needs a spare ecu!

safc $175 -can be used control a turbo engine, im doing it now.

b18a sb $350 -shortblock, includes everything from the head down. also
includes unorthadox racing alternator/crank pully.

b16 sb $200 -good condition shortblock, swapped out in favor of ls/vtec.

eg6 shell $1000 -would make a good trailer whore race car, mechanically sound, not the prettiest though.

gsr brakes $150 -everything needed to upgrade those tiny civic brakes

gsr sway $30

dc SS $60 -dc sports short shifter, very short and smooth shifts.

MSD $100 -MSD ignition with rev limit, includes 8k rev limit, and msd external coil and msd distributor cap setup.

s bar $20 -generic strut bar, cheap good looking effective upgrade

2.5 ex $160 -custom made 2.5 inch exhaust, magnaflow muffler. quiet and powerful.

txs mbc $50 manual boost controller much better than any crappy homemade controller

hks tt-t1 $90 -HKS turbo timer Type 1 very good auto timer, silver metric version, records 1/4 time 1/8 0-60 etc

hks air $35 -HKS air filter, great flow and good trapping, authentic HKS

pod $20 - 2 gague pod(a pillar) black
AF g $20 -autometer air fuel gague. LOOK AT THE LIGHTS ooooo
Boost $30 -autometer boost gague white back works well
inline $50 -inline fuel pump, works well includes relay, good for at least 230whp at denver with 12:1 afr.
AC sys $150 -99% complete AC system for 92-95 civic, includes condensor, compressor, lines, hoses, etc.

let me know who wants what, i am located near glenwood springs, i can meet half way if needed. shipping also available(you pay)

ANY parts off the car are available, body, trim, etc. just ask!

for a few pics go here www.geocities.com/tek_civic/

samssf
06-14-2004, 10:15 PM
sounds interesting... I wonder what would fit onto my 98 civic EX...

fodo
06-14-2004, 10:42 PM
sounds interesting... I wonder what would fit onto my 98 civic EX...

motor should drop right in.

tek
06-14-2004, 11:17 PM
yeah motor will go right in, i have everything that would be needed. you would probibly need to buy a obd-II to OBD-I conversion harness(approx $150) or you could do it yourself if your not afraid of wiring etc.

redlinercg1230
06-15-2004, 07:18 AM
hey i was just wondering if you would want to trade you shell for a 1987 rx7 shell it has motor but the rear rotor gave out and how much would u you include that b18a for with the trade if u take it.

floored4door
06-15-2004, 09:40 AM
[QUOTE=tek]turbo $1500 -everything, all piping, hks turbo manifold, t28 turbo, greddy type s BOV, small but effective FMIC, everything you need for turbo(minus fuel stuff) also including a custom side exit downpipe(outta front bumper) with 2 o2 sensor spots. <--- How many Miles? 75K?

gsr sway $30 <--- Does this include the mounts and end links? Howabout hardware?

MSD $100 -MSD ignition with rev limit, includes 8k rev limit, and msd external coil and msd distributor cap setup.<---- which MSD is this? Will this cap fit on a GSR? Is the rev limit Adjustable? [QUOTE]

amidothers
06-15-2004, 09:48 AM
Could use the A/F guage... I am in Golden, we can meet or ship it, doesn't matter to me...

tek
06-15-2004, 02:32 PM
[QUOTE=floored4door][QUOTE=tek]turbo $1500 -everything, all piping, hks turbo manifold, t28 turbo, greddy type s BOV, small but effective FMIC, everything you need for turbo(minus fuel stuff) also including a custom side exit downpipe(outta front bumper) with 2 o2 sensor spots. <--- How many Miles? 75K?

gsr sway $30 <--- Does this include the mounts and end links? Howabout hardware?

MSD $100 -MSD ignition with rev limit, includes 8k rev limit, and msd external coil and msd distributor cap setup.<---- which MSD is this? Will this cap fit on a GSR? Is the rev limit Adjustable?

i don't know the milage on the turbo and relate parts but i think it is reasonable. the turbo ocassionally puffs a little blue smoke, just a seal somewhere. spools up fine, works well.

gsr sway, yeah all mounts and bolts etc. anything you need.

msd, not sure exactly, the front is scratched. but i think its the 6al since it has a rev limiter that is changable with the use of other rpm pills. cap will fit a gsr.

im not all up for delivering a small priced part, gas alone is almost worth the part, so if you want to do some shipping let me know.

Slava
06-15-2004, 02:40 PM
How much for the stock side skirts and hatch struts. The two that hold the rear window up?

oMekone
06-15-2004, 02:43 PM
trade you a 2001 gsr tranny for your b16 tranny?

tek
06-15-2004, 03:39 PM
trade you a 2001 gsr tranny for your b16 tranny?

sorry no trades for honda stuff, don't have a car to put it on.

name a price for the sideskirts and hydrolics, im not sure what to ask, how about $70? let me know what you think, they both work well, strong pick up.

Slava
06-15-2004, 03:46 PM
I'll give you $50

lswhitecivic
06-15-2004, 05:03 PM
Are you parting out the interior as well? If so i need a heater control unit.

Ben

tek
06-15-2004, 05:40 PM
Are you parting out the interior as well? If so i need a heater control unit.

Ben

yes any part on the car is for sale. if you want it you got it, how much? pm me if you want.

$50? ok, how do you want to do this? pm me if you want.

turbolaser
06-15-2004, 08:32 PM
would you be interisted trading the turbo set up for a 91 explorer 4x4 runs good let me know thanks

tek
06-15-2004, 10:19 PM
hmm, turbo laser i might be interested, let me know more details. pm me with all the info, and a pic if possible.

oldskoolracer
06-16-2004, 09:55 PM
can we meet. i want the msd.
will pick up this week. need more details..

very soon...........pm or email.

tek
06-19-2004, 08:33 AM
hmm, turbo laser i might be interested, let me know more details. pm me with all the info, and a pic if possible.

bump. still have most of this stuff

oldskoolracer
06-19-2004, 11:55 AM
still waiting for reply.
pm me again.

93tegLS
06-20-2004, 02:25 PM
Hey I want the kit for the ls/vtec conversion! How's $150?

oldskoolracer
06-21-2004, 09:28 AM
still have the msd?????????