92 civic ex rear disk swap need help

[sup_uni]

i have the entire system pulled out of a 92 civic ex and put into my lx but my problem is the fitting on the master cylender is too small on my car is there any way that i can just go and pick tis part up at a local napa or do i have to special order this part from say honda or some place here on the net, if anyone knows where i can get this fitting please tell me. i need my car to drive to work and i cant drive it when the fitting isnt going in so as fast as anyone can please tell me thanks.

[HONDA GHANDI]

What fitting are you talking about? The brake lines to the master cyl?

[sup_uni]

there is a master cylender on the brake system mounted right on the brake booster. the brake line i am talking about is the one that connects to the master cylender twords the rear of the car and it isnt the right size fitting, i have heard or read of poeple flaring out the brake line or something liek that to make it fit

[HONDA GHANDI]

You will need the fitting off the EX or Si, and a flaring tool to do it right. I think you can get the fitting at Napa, as well as the flaring tool.

[12seccivy]

there is a master cylender on the brake system mounted right on the brake booster. the brake line i am talking about is the one that connects to the master cylender twords the rear of the car and it isnt the right size fitting, i have heard or read of poeple flaring out the brake line or something liek that to make it fit

Wait a sec!
Did you also put the abs system in too?
I noticed that the ABS hondas have the larger flange in the rear of the master cylinder..

[sup_uni]

Wait a sec!
Did you also put the abs system in too?
I noticed that the ABS hondas have the larger flange in the rear of the master cylinder..


no i ripped the whole abs system off the car

[white_n_slow]

I may have the fitting you need. PM me :)